21
on: May 17, 2024, 07:50:29 AM
|
Started by Galactica - Last post by Steve G.
|
Splitting the cases should not be taken lightly!!
|
|
22
on: May 17, 2024, 07:44:51 AM
|
Started by Galactica - Last post by Galactica
|
Could be a bent shifter fork. Most likely if a fork is bent, it’s because the dogs and ears are worn, then the gears slip apart and bend the fork. One problem causing the other, I’m thinking.
|
|
23
on: May 17, 2024, 07:30:06 AM
|
Started by Kiwi_Roy - Last post by Steve G.
|
Weather this Sunday looks sunny. I’m headed over to the BCOM swap meet Sunday. Not sure yet if I’ll head for coffee first.
|
|
24
on: May 17, 2024, 07:26:08 AM
|
Started by Galactica - Last post by Steve G.
|
JASO MA and JASO MA2 rated engine oils both have specific additives for wet clutch operation, and longer chain molecules for gearbox operation.
Ross, are you concerned that you may have a bent shifter fork?
|
|
25
on: May 17, 2024, 07:02:41 AM
|
Started by Galactica - Last post by Twisted_Twin
|
A trick from the Bevel Ducati guys that I found when I was trying to get the clutch in my 860 to stop slipping (it worked) .
Those clutch plates probably sat dry and stuck together for a long time.
Before spending a pile of money on transmission parts, I'd try pulling the clutch friction discs out and soaking them overnight in some ATF.
Transmission fluid has friction modifiers in it that are specifically for wet clutches. Engine oil doesn't have this and since it's a unit engine....
Won't cost much and beats tearing down the transmission.
|
|
26
on: May 17, 2024, 06:30:11 AM
|
Started by Galactica - Last post by Galactica
|
Ya, it’s JIS. Thought I’d push some buttons.
The screw was staked at the factory and you can see it hasn’t moved. I thought it would be too good to be true. So I’ll get the gasket and ride it a bit more maybe, to try a get a definitive diagnosis. But I’m pretty sure I’m looking for a transmission or parts there of.
|
|
27
on: May 17, 2024, 05:45:44 AM
|
Started by Galactica - Last post by Steve G.
|
I’m assuming you mean Ohillips head rather than cross head Ross? Your entire motorcycle is fastened together with JIS head screwdriver heads. I strongly suggest getting all 3 different sized heads at Princess Auto. You may need to buy a multi head tip mini box.
Vessel JIS screwdrivers are the best made .
|
|
29
on: May 17, 2024, 03:52:30 AM
|
Started by Galactica - Last post by hardrockminer
|
That would be JIS crosshead? I use impact screwdrivers if they are tight.
|
|
30
on: May 16, 2024, 10:02:15 PM
|
Started by Galactica - Last post by kilowop
|
Having occasionally had similar situation arise, I was advised to push it over a cliff and declare it stolen.
|
|
|