|
2
on: Today at 03:52:30 AM
|
|
Started by Galactica - Last post by hardrockminer
|
|
That would be JIS crosshead? I use impact screwdrivers if they are tight.
|
|
|
3
on: May 16, 2024, 10:02:15 PM
|
|
Started by Galactica - Last post by kilowop
|
|
Having occasionally had similar situation arise, I was advised to push it over a cliff and declare it stolen.
|
|
|
4
on: May 16, 2024, 06:52:19 PM
|
|
Started by Steve G. - Last post by Steve G.
|
|
The Moto Social. A world event held year round. During our winters it’s held every month in Auckland, Christchurch, Sydney, Johannesburg, Melbourne , etc, during our summer this week, Los Angeles, New York, London, etc. weather permitting of course, a massive turnout.
#VANCOUVER!!! Invite all your pals and come kick it with us at @TheMotoSocial.
|
|
|
5
on: May 16, 2024, 05:51:57 PM
|
|
Started by Steve G. - Last post by Steve G.
|
|
Yeah surgery May 28th.
I’m still dog sitting in Aldergrove till Friday night. I recon I’ll check that place out Saturday. Unless you give everyone the heads up that it’s a waste of time!!
|
|
|
6
on: May 16, 2024, 04:23:19 PM
|
|
Started by Steve G. - Last post by Galactica
|
|
Thanks Steve. Might go check it out tomorrow. Btw, when is your surgery? Near the end of the month, no?
|
|
|
7
on: May 16, 2024, 04:18:12 PM
|
|
Started by Galactica - Last post by Galactica
|
|
So having the gasket on order, I decided to open up the transmission cover. Mine is a #3 cross head not Allen head. Tight as can be. Dang. Now I’m thinking the worst. Splitting cases and sourcing transmissions/parts.
|
|
|
8
on: May 16, 2024, 10:20:51 AM
|
|
Started by Galactica - Last post by Galactica
|
|
Left side transmission/shifter cover gasket ordered. Hopefully it will be here end of next week.
|
|
|
9
on: May 16, 2024, 08:26:28 AM
|
|
Started by Galactica - Last post by Galactica
|
|
Ya, I laid awake much of last night with it going through my mind. I actually am fairly certain it’s not the clutch. It reminds very much of the KZ1000 LTD I did. The dogs and slots on a couple of transmission gears were worn and it jumped out of gear under load.
I posted on the SOHC forum. It was suggested that there’s an Allen screw on the end of the shift barrel that holds on the gear shift side plate that has possibly come loose. Have to pull off the left side transmission cover to check. Requires having a new gasket on hand. I’ll order one today. I’ll see if they’re available at Honda. I’m sure hoping I don’t have to split the cases.
|
|
|
10
on: May 16, 2024, 05:18:24 AM
|
|
Started by Galactica - Last post by rz5mark
|
|
Be sure the hub bearing or bushing is in good shape.
|
|
|
